BMW 318i, 540 motor, ESC, clear body, tires, foam bumper, 19 tooth pinion gear, 61 tooth spur gear, window mask decals, two sets of wheels and instruction manual

Features

Chassis: TT-01 type E composite chassis-compatible with a variety o Tamiya Option Parts.
Drive: Four wheel shaft drive.
Electronic Speed Control: Tamiya TEU-104BK with reverse, TAMM4541.
Motor: 540 motor with pre-attached leads.
Ball Bearings: Installed in differentials, bushings in wheel hubs.
Shocks: Friction, plastic body.
Gearbox: Sealed, front and rear.
Differentials: Bevel gear, ball bearing equipped.
Transmission: Single speed.
Body: Clear untrimmed, with window mask and body trim decals.
Tires: Slick 1.0" (26mm) wide, 2.6" (65.5mm) diameter.
Wheels: Matte chrome 2.0" (52mm) outer diameter, 0.94" (24mm) wid +2° offset and white colored set with zero offset.
Bumper: Front foam.
Suspension: Independent double wishbone.
Camber: Non-adjustable, camber refers to the angle of the tops of th tires from vertical when viewed from front or behind vehicle.
Caster: Non-adjustable, caster/toe-in refers to the angle of th front suspension when viewed from the side of the car in relatio to the chassis.
Steering: Bell-crank type with servo saver.

Requirements & Suggestions

Radio: 2-channel with one standard servo
Radio Batteries: 8 AA size (for transmitter)
Battery: 6-cell stick pack with standard connector
Charger: AC/DC timed or peak for 6-cell battery
Misc. Items: Building and track equipment

Comments

For replacement, or to upgrade to Ball Bearings use Qty. Size Locatio Qty. Bearing Se 2 5x11mm Front Hub 1 DTXC154 2 5x11mm Rear Hub 1 DTXC154 2 8x12mm Front Dif 1 DTXC158 2 8x12mm Rear Dif 1 DTXC158 2 5x11mm Fr Driveshaft Joint 1 DTXC154 2 5x11mm Rear Driveshaft Joint 1 DTXC1547.